replies Archived Message
Posted by john sartain on September 30, 2005, 9:59 pm, in reply to "Re: Peugeot 406 Hdi 1999 Bosch 15C2"
Follow wiring loom from ecm.
It turns through 180 degrees
and comes back on itself.
by design fault it is cable tied
to metal bracket top timing belt
cover and chaffes its way through
into wiring loom.
check also for voltage drop problems
around the loom
hth john sartain
|
| Message Thread:
- Peugeot 406 Hdi 1999 Bosch 15C2 - Will not rev over 2100 rpm, air mass meter? - Jim Watson September 29, 2005, 4:36 pm
- replies - Steve Harvey September 30, 2005, 8:30 am
- replies - Jim Watson September 30, 2005, 8:45 am
- replies - Jim Watson September 30, 2005, 6:28 pm
- replies - simon dean September 30, 2005, 9:40 pm
- replies - Roy Ritchie September 30, 2005, 9:40 pm
- replies - john sartain September 30, 2005, 9:59 pm
- replies - Jim watson October 1, 2005, 9:50 am
- replies - Jim watson October 3, 2005, 8:16 pm
- fixed - Jim watson October 4, 2005, 8:29 pm
|
|