Back to Forum
Post a Response
    replies Archived Message

    Posted by Steve Norman on March 14, 2006, 8:52 pm, in reply to "2001 Range Rover 4.6 Vogue (P38) Heater Matrix 'O' Rings"

    Hi Andy,
    I knew you would have to work on it soon

    It's not too bad a job, as Andy has said.
    I usually leave the vent duct in place, but just move it enough to get behind it.

    The side of the centre console needs a bit of brute force to slide it the correct way to remove(see Rave).

    The small retaining screw is the worst part to free initially, make sure you use a good fitting screwdriver.

    When refitting, make sure you screw the screw hand tight & check the flange is square, before tightening fully & all should go back together easily, (by this time you may have slightly red marks on your arms, due to plastic pressing on them & be able to focus while looking upside down

    HTH

    Regards
    Steve

    Message Thread:


Copyright © uk autotalk