Back to Forum
Post a Response
    replies Archived Message

    Posted by andyhyoung on March 14, 2006, 6:45 pm, in reply to "2001 Range Rover 4.6 Vogue (P38) Heater Matrix 'O' Rings"

    I have done loads of these without removing the dash.The best method is to remove the centre console and as much plastic heater trunking as possible.You may have to cut a section out carefully with a sharp knife but it goes back ok with plenty of gaffer tape.Make sure you locate squarely onto the water pipe retaining screw for the clamp(usually a cross head)cos they are normally tight.Not as bad as it looks!! good luck

    Message Thread:


Copyright © uk autotalk