fixed Archived Message
Posted by dave jackson on September 12, 2005, 9:44 pm, in reply to "Re: Freelander 2001 TD4 clutch and Airmass"
Sorry guys
been away on holiday so i forgot all about this one. Thanks Steve for the info on clutch job.
Nothing to worry about here guys not a bad job at all. left the transfer box up and supported it, hydraulic lines and master cyl were on back order so i just replaced full clutch and hyd bearing, if you fill up the tiny reservoir and then connect the push on fast fit connector from hyd bearing pipe it does not seem to require any bleeding. job took about 5.5 hours and book time was about 8 so good money to be made here.As for the AIR MASS well thanks must go to Tony sefton for convincing me to try an alternative air mass. The dealer part is £154.20 +vat, it is also the same air mass as the BMW diesel's and the Rover 75 diesel. I purchased a VW/bosch Air Mass part No 0280 218002 this was £43.98 exchange and it worked perfect. the only problem is that this is an exchange part so you will have to use the original outer air pipe and swap the sensors over. Also if like myself you have your parts delivered then you may want to swap these over out of sight of the parts delivery guy and dirty that new looking pipe up a bit as your gonna be sending it back for the exchange deal.
Cheers
Dave
|
|