replies Archived Message
Posted by Steve Norman on February 5, 2005, 8:03 am, in reply to "land rover / discovery se /1996 / 3.9 /"
Hi Ken,
As John said, are you sure the power to the coil is OK under load?
See the archive link below. Also:On your vehicle (should be TA chassis on 96), so you can just buy the little link lead & plug in. For your ref: vehicles from TA501920 have a spider, the bypass lead is: AMR4956 £2.38+vat.
Vehicles from VA534104 need the lead with extra to show signal back to alarm ecu,: AMR4965 £96.00+vat.
spider is behind the radio, (hands cut/bleeding job), you are supposed to take centre facia out, but can just do through radio hole. the unit has a ten way plug, all black wires.
Usually the spider units can be taken out, the dry joints re-soldered & then refitted. (best option).
To bypass without special lead, or to bypass just one circuit, join wires together as needed below:
Pull plug off, look at it with wires pointing away from you & the clip on the RH side.
pin connections are :
++++++++++++++++++++++
+ 2 + 4 + 6 + 8 + 10 +
++++++++++++++++++++++
+ 1 + 3 + 5 + 7 + 9 +
++++++++++++++++++++++
Join pins 2 & 3 for fuel pump.
Join pins 6 & 10 for starter
Join pins 4 & 8 for ignition coil
After that, leave remaining wires alone & plug back into spider to keep alarm happy
Regards
Steve
|
Link: http://www.ukautotalk.com/archive/ukat836.htm
|