Back to Forum
Post a Response
    Re: Discovery TD5 Archived Message

    Posted by Michael Burgess on August 13, 2010, 7:26 am, in reply to "Re: Discovery TD5"

    Hi Andrew. No I did not replace the spiggot bearing but I did check it. This noise is more noticed when engine is cold than hot. If you push the clutch pedal down to floor hard, it goes. If you release slight pressure then it is back. If you back off a little bit more, then it is gone again. There is no judder in operation just sounds like a noise you get when a carbon thrust bearing is worn.

    Message Thread:


Copyright © uk autotalk