I was called to a garage who had changed the clutch on this vehicle.
Unfortunately they had done the job without setting things in place via a scanner before hand
So when i ran the relearn procedure the clutch actuator did not move.
As a result the gears run through their relearn correctly but when engine is run it will not select gear as the clutch actuator does not move.
Is there anyway of resetting this or what has to be removed to reset then replace and relearn?
And if possible, in what order is this to be done?
I have relearn program on the DEC and Snap On and probably Delphi but haven’t checked that.
Thanks
Andy