Year of Manufacture *: 003
( Optional ) Engine Code or CC: HDi (RHY)
Customer complaint is that when he switched the wipers on, they wiped once and then never went again.
I have just replaced the starter motor (lots of current, little cranking)and the customer has been using jump leads, so spiking is a possibility.
Reading the comms 2000 unit the switch status can be read and are working correctly. Reading the BSI however always shows the wiper signals as "inactive".
In output test mode it is possible to remove the ground signal on the slow speed drive but not get 12v on it, although sometimes on reboot the 12v is there briefly, unfortunately the motor was not connected at the time.
For completeness the motor has been checked and runs on both speeds at reasonable current.
Relevant configuration data appears correct, no rain sensor etc.
I also performed the procedure to put the BSI into and out of default mode (Robert Cruickhank posted that, thanks Robert) with no improvement.
Software update of BSI has been mentioned also.
Any Peugeot Citroen experts able to offer me some advice?
Shaun
Message Thread
« Back to index | View thread »
Copyright © uk autotalk