Year of Manufacture *: 2001
I had a mondeo come in customer complained about a noise from front i drove the car only a few yards then put it on the ramp jacked up front to check over and o/s front bearing totally shot. I then replaced front wheel bearing and had to replace A B S sensor due to poor condition all ok. tried vehicle all brakes worked ok but when driven very slowly with repeated brake application first time ok then second application pedal goes hard with minimal braking as though servo vacuum not working and a sensation as though A B S is trying to work? I code read vehicle no codes went to live data to check sensors all seem to be working but when this occures data shows n/s front A B S valve opens? I'm using a Modis and I did have some comms problems to start with but got into it aventually.But my confusion is why does the pedal go hard with poor braking but if you remove A B S fuse and and disconnect A B S light comes on but brakes are perfect? Also I don't know if vehicle had problem before i done wheel bearingAnyone had simular problems
Message Thread
« Back to index | View thread »
Copyright © uk autotalk