I Also think that when the system sees a bulb failure or a poor connection, It shuts the power off to that light and doesn't work again until the lights have been turned on and off a few times.
We did the usual fix of soldering an earth wire to the circuit board earth connection and snipping the earth wire out of the plug and joining with a bullet connector.
If you wanted to be professional, I suppose you could replace the bulbholder and replace the pin in the plug but I know which will last the longest.
p,s you have to look close as the burnt connection may not look bad, but doesn't have to be really bad to cause chaos on this modern stuff.
H.T.H Tony.
Message Thread
« Back to index | View thread »
Copyright © uk autotalk