Hi all

I had a customer pop in today complaining his hard top won't go down, on inspection the fault is present. On operation of the switch I can hear the hydraulic motor working, boot lid tilts & windows go down but no movement in roof. When I connected the Autocom I was left with over 30 fault codes in rear sam module but they were all intermittent & didn't appear to tie up with this fault, on live data boot switch, boot shelf & switch operation for roof open/close appears to be ok. Does anyone know if there is an isolator switch on the a pillar as I can't see any other switch on autocom.
Does anyone have any known issues or wiring diagrams covering this area as e3 & autodata haven't .
I have carried out a global fault code clear as there is probably 60 fault codes throughout all the modules & let the customer take the car away until I can find more information

Many Thanks
John

Managed to get a diagram, E3 managed to find one, many thanks to E3

Hello john,
Are the reversing sensors all working?

Hi Ian, thanks for your reply, I never checked that to be honest but there wasn't any codes showing a problem in that area, I will check though.

Regards

John

Had one recently with same problem,the wiring in the roof had split where roof panel folds.remove head lining to check,mine was obvious when removed
Steve Sneap

Thanks for that Steve, could be the potential issue with this one, will hopefully get him back in

Regards