Garage Support

Post a Response

Mercedes Benz Sprinter 311 CDi 2006 - Brake pads warning light reset? #

Posted by Paul Goswell on September 6, 2012, 6:09 pm

Year of Manufacture *: 56 plate

Hi

Can any one tell me if there is a brake pad warning light reset on these, i am pulling my hair out fitted new discs and pads on front and light wont go out, i have checked resistance up to connectors behind splash panels and its all ok thanks

Paul

Re: merc sprinter 311 cdi

Posted by Ian Baxter <iframe src='https://members4.boardhost.com/ukautotalk/info/user=UKAT1560' width='330' height='300' border=0 style='border:none;'> on September 6, 2012, 7:16 pm, in reply to "merc sprinter 311 cdi"

Hello Paul,
No there is no reset procedure on these, but I would always fit original Mercedes new wear indicators because aftermarket can give problems like this

,and also check the rear ones to in case they are cooked, as well as Brake fluid level sensor.
HTH,
Ian.

Re: merc sprinter 311 cdi

Posted by paul goswell <iframe src='https://members4.boardhost.com/ukautotalk/info/user=UKAT5240' width='330' height='300' border=0 style='border:none;'> on September 6, 2012, 8:28 pm, in reply to "Re: merc sprinter 311 cdi"
Paul Goswell

after fitting new front discs and pads i presumed the rears must be out too, so fitted new rear pads and sensors but light still on, so fronts were the or are the problem, i fitted old front sensors but cut and joined wires to make circuit and light still on then checked continuity up to sensor connector behind splash guard and circuit ok, does it need to see a resistance or just a make and break circuit

Re: merc sprinter 311 cdi

Pretty sure there must be resistance needed unlike the earlier Sprinters and 307s etc, because I've had problems with the wrong ones even supplied by Mercedes dealer, The correct ones solved problem

Ian.

« Back to index

[ Garage Support ]