Range Rover Sport 2005 - Suspension fault c1a13-64 IDS #
Posted by John Womack on June 10, 2012, 3:06 pm
Year of Manufacture *: 2005
Hi all
Suspension goes in to default only code c1a13-64 pressure does not decrease when venting gallery. Also if you select access level front drops but rear stays at same height then dash warning that something under vehicle & raises suspension fully.
Replaced rear height sensors and recalibrated told by landrover man cures all problems.
Can actuate all valves in ids , but could still be sticking or blocked,check all pipes possible but none trapped asfar as I can see. can deflate suspension with scan tool front drops first then rear after.
Only thing I have not checked is vent pipe as I cannot find it, or work out which it is or the direction it goes in,vent valve seems to be tucked in chasis or body under passenger seat does this have a filter or breather fitted. need to eliminate this first I think unless anybody has a silver bullet.
John
Re: range rover sport suspension fault c1a13-64 ids
john at the compressor head remove the exhaust vent ,from memory a 14mm head,they become blocked not allowing complete release ,theres a modifyied part in the states,not in uk!! hth keith.
Re: range rover sport suspension fault c1a13-64 ids
had trawled internet on this land rover did some mods on these a while ago. took compressor assy off to find ally houseing corroding so bit the bullet new unit ordered with air dry & silencer as well.spoke to land rover man who knew best way to prove it was in compressor unit with out too much dismantling ,not easy access all tuck away in chasis.
on June 12, 2012, 8:40 am, in reply to "