Garage Support

Post a Response

Vauxhall Vectra C X18XE 2004 - Programming new instrument cluster #

Posted by Nigel Bennett on February 24, 2011, 11:23 pm

Year of Manufacture *: 2004
( Optional ) Engine Code or CC: X18XE

Hi All..
Trying to program a new instrument cluster with Vagcom. First one!

1.Cluster was dead so i was unable to collect configuration data.
2.Fault codes present are; Can communication with engine ECU and AHL( auto head lamp leveling).This vehicle doesn't AHL.I have been through all the other controllers and can't find the AHL present in any of them.
Any help with these issues Please.
Nigel.

Re: Vauxhall / Vectra C

Posted by Andy Evans User icon on February 25, 2011, 8:17 am, in reply to "Vauxhall / Vectra C"

I think the problem is you are using Vagcom on a Vauxhall

Andy E

Re: Vauxhall / Vectra C

Posted by Nigel Bennet on February 25, 2011, 9:03 am, in reply to "Re: Vauxhall / Vectra C"
Message modified by board administrator February 25, 2011, 2:22 pm

Sorry.yes of i mean Vauxcom...

Re: Vauxhall / Vectra C

Posted by Terry Wood User icon on February 26, 2011, 3:51 pm, in reply to "Re: Vauxhall / Vectra C"
Terry Wood

Hello Nigel

What were the codes and where are they stored?

I have an earlier version of TIS V91 05-08
NOT SURE IF THE INFO IS STILL VALID

Couldn't find a listing for engine code x18xe but for z18xe there are two instrument code index's depending on if its an estate or hatchback

------------------------------------------------

Selected Vehicle Configuration:
•Vectra-C/Signum
Hatchback
Instrument
2002-2005
Engine
Z18XE
Code Index 001

------------------------------------------------

Selected Vehicle Configuration:
•Vectra-C/Signum SIGNUM
Station Wagon
Instrument
2004-2005
Engine
Z18XE
Code Index 003

------------------------------------------------

Can you go back into instrument programing and check configurations?

I think from memory when i had a problem with a incorrect instrument programing configuration on a Astra H I had to reset instrument so I could get back into programing configuration and start again from the beginning.
But that was with using Tech 2

HTH
Terry

Terry@ydhost.co.uk

Re: Vauxhall / Vectra C

Posted by Nigel Bennett User icon on February 27, 2011, 2:07 pm, in reply to "Re: Vauxhall / Vectra C"
Nigel Bennett

Thanks Terry for taking the time to reply.
Sort this one out with the new software for Vaxcom,
we were using a out of date version.
Also thanks to Derick Edwards for putting on the right track.
Thanks again.
Nigel.

« Index

[ Garage Support ]