Garage Support

Post a Response

Citreon Berlingo 1.9 WJY 2004 - Alternator fault, code P0335 #

Posted by Jeff Henderson on December 20, 2010, 2:11 pm

Year of Manufacture *: 2004
( Optional ) Engine Code or CC: 1.9 wjy

Hi all

customer called me to his berlingo with alternator light on permanently. He had fitted a new alternator and new clocks but fault still there. I code read it the only code is p0335 rpm sensor

I can trace the d+ feed into eng bay fuse box but its difficult to find the output...i presume it goes into the bsi because the heater is inop also and i'm sure it triggers of the d+ term... any suggestions appreciated

Thanks

Regards Jeff.

Re: Citreon Berlingo 1.9 WJY 2004 - Alternator fault, code P0335 #

Posted by Dav Littlewood <iframe src='https://members4.boardhost.com/ukautotalk/info/user=UKAT2772' width='330' height='300' border=0 style='border:none;'> on December 20, 2010, 6:34 pm, in reply to "Citreon Berlingo 1.9 WJY 2004 - Alternator fault, code P0335 #"
Dave Littlewood

Can you verify if the rpm / running signal is working.
From past experiance the bsi needs to see the engine running signal.

Has the gearbox been off?
Magnet(s) in the flywheel can drop out so that a signal is not produced at rpm sensor

Re: Citreon Berlingo 1.9 WJY 2004 - Alternator fault, code P0335 #

Posted by Vince Mosley <iframe src='https://members4.boardhost.com/ukautotalk/info/user=UKAT2919' width='330' height='300' border=0 style='border:none;'> on December 21, 2010, 2:07 pm, in reply to "Re: Citreon Berlingo 1.9 WJY 2004 - Alternator fault, code P0335 #"
Vince Mosley

Had one similar to this back in the summer, and it was alternator, replaced cleared codes and worked fine for 2 days then same problem. Reset the control module to accept new values and all ok. HTH

citreon berlingo 1.9 wjy

Posted by Jeff Henderson on December 22, 2010, 6:54 am, in reply to "Re: Citreon Berlingo 1.9 WJY 2004 - Alternator fault, code P0335 #"
Message modified by board administrator December 22, 2010, 3:52 pm

Thanks dav and vince , vince when you say reset the control module do you mean the bsi?

« Back to index

[ Garage Support ]