Back to Forum
Post a Response
    Replies Archived Message

    Posted by Steve Hankinson on February 11, 2004, 10:53 pm, in reply to "Chrysler Grand Voyager 3.3 V6 2001"

    Try these, one might be right!

    ChryslerVoyager LX, Mod.98/991998Look into the engine compartment, and on the right hand side, next to the battery or on opposite left side too, you can find the gearboxcontrol computer (description 58). The white/orange cable, carries the signal. This cable goes to the engine control coWhite/orange.

    ChryslerVoyager TD1995Three connectors are located above each other, at the front passenger side, at the bulkhead. The grey 10 pin connector (bottom one) has the signal at pin 4.White/orange


    ChryslerVoyager V62001Turn steering wheel to RH full lock. In LH wheelarch there is a bundel of wires. Behind that is a removable grey cap covering a sensor in the transmission casing. There are 2 green wires, the signal is slightly noisy so a filter is required.


    ChryslerGrand Voyager1995There are two black connectors to the engine control unit in the engine compartment, above the wheel housing (drivers side). The lower 30 pin connector, has the signal at pin 66.


    ChryslerGrand Voyager19911995In this series, a black connector with the speed pulse at pin 47 is located in the engine compartment next to the battery.
    ChryslerGrand Voyager 2.5TD2001


    Chrysler Grand Voyager 2.5D Limited Edition Model Year 2001, there is as 3 pin plug on top of the differential and the colour is blue/orange.
    Chrysler

    Grand Voyager LE 3.3l1996White/orange. In the engine box on the 60 pin connector Pin 47.
    Chrysler

    Grand Voyager LE Diesel GS1996White/orange. In the engine box on the grey 10 pin connector
    Chrysler

    Grand Voyager LE GS 3.8l1996White/orange. On the ECU on the black 40 pin connector Pin 66

    Link: http://www.autoelectronix.co.uk

    Message Thread:


Copyright © uk autotalk