Ford Transit Dura-Torq 2.4 Di 2003 - Non start after clutch replacement - Fixed #Archived Message
Posted by Ali Nassar on October 7, 2010, 7:05 pm
HI ALL FORD TRANSIT CAME IN WITH CLUTCH SLIPPING ,AFTER PUTTING A NEW RIGID FLYWHEEL KIT , THE VAN WILL START FOR THREE SECONDS THEN DIES. CLEARED THE FAULT CODES , TRY AGAIN ,SAME CODES CAMES BACK.P1666-CRANKSHAFT SENSOR,PUMP NOT PLAUSIBLE P1564 INJECTION PUMP INJECTION QUANTITY P0335 CRANKSHAFT POSITION SENSOR MALFUNCTION P1631 ECM/PCM MAIN RELAY FAULTY. ???? SENSOR WAS OK BUT IVE PUT NEW ONE JUST INCASE.MAIN RELAY IS OK .IMMOB. OK LED STAYS ON FOR 3 SECOND THEN IT GOES OF.IVE SCOOPED SIGNAL FROM TDC SENSOR ALL GOOD. ALL WIRING ARE FINE ,WHAT CAN I DO NEXT , HELP PLEASE. ONE MOR THING , IVE TAKING THE GEAR BOX OUT AGAIN TO CKECK IF SOME THING WRONG WITH THE FLYWHEEL AND IVE PUT THE OLD FLYWHEEL BACK WHITH OUT THE GEAR BOX , TRY TO START ,NO GO EXACTLY THE SAME . I NEED A DRINK!!!???