Back to Forum
Post a Response
    Re: Toyota Estima 2.2 1993 - Failed water pump # Archived Message

    Posted by Steven Humphreys on October 1, 2009, 6:13 pm, in reply to "Toyota Estima 2.2 1993 - Failed water pump #"

    Hi Ken

    These are not too bad to do. Seats out and floor out then remove timing covers, turbo pipes etc, you will have to unbolt auxillary driveshaft at crank pulley then you should just have enough room to push it to one side to get crank pulley off, we use a fabricated plate to attach slide hammer to remove pulley it will be tight coming off, when exposed carefully mark pulleys and remove belt (I did post a link on ukat a while ago with photos on timing these up)then remove pump bolts, I think there is a couple that are not obvious at top of engine from rear but you will see them, when you have fitted your new belt and pump make sure cooling system is bled up correctly as these have a habit of cracking cylinder heads.

    Steve

    Message Thread:


Copyright © uk autotalk