Re: Peugeot partner 2.0 hdi electrical fault Archived Message
Posted by simon dean on February 12, 2009, 6:47 am, in reply to "Re: Peugeot partner 2.0 hdi electrical fault"
Hi Graham You dont really need wiring diagrams for this... You need a scan tool that will allow you to look at bsi parameters and activations....ok if you have one....really difficult if not. just for info you could read bsi inputs from wiper/signal stalks if it has a comm2000 this would tell you stalks ok and being recieved at bsi you could also activate components..wipers..indicators directly with a sacn tool this would tell you bsi relays are good... this vehicle is very prone to bsi failure due to water ingress just remove it and tip it upside down first..probably save you lots of time to fit you will need access code to code keys...you can purchase this bsi from your dealer already configured but you will have to wait for it to be done from peugeot... your biggest headache will be curing water ingress to stop it happening again...piles of s**t they are hth simon
|
|