Back to Forum
Post a Response
    Re: Land Rover Freelander 2.5V6 2003 ABS Archived Message

    Posted by UKAT5440 on November 6, 2008, 8:47 pm, in reply to "Re: Land Rover Freelander 2.5V6 2003 ABS"

    Thanks for the replies.
    I scoped the sensors again this afternoon, connected and with the ignition on this time, there is a signal from all apart n/s/r But somebody has fitted a rear sensor to the n/s/f(shorter wire) so I will put that one on the rear tomorrow and see if I get a signal then. If I do I'll get the proper one for the front.

    Just wondering how you would check if it is the sensor, bearing, gap etc with out substitution?

    Forgot to say this is an auto so the hill descent switch is on the center console behind the gear selector. I checked this at the Modulator wire 12v on 0v off.

    I will have a look at the can lines & comms when I get the sensor signals sorted.

    Thanks Russ

    Message Thread:


Copyright © uk autotalk