Year of Manufacture *: 2007/8
( Optional ) Engine Code or CC: Z16 XER
having a problem with the easytronic gearbox!
Car came in crunching into all gears. After bleeding clutch and re-setting the clutch touch point adaptation the fault remained so a new clutch and concentric were fitted (Sachs).Upon inspection the pressure plate diaphragm spring was broken explaining the crunching.However the crunching remained even after following the clutch bleeding procedure on Vaux-Com. I then attempted to program the clutch touch point adaptation and the gearbox parameters to no avail, now the dreaded "F" is displayed in the instrument cluster and it will only start when prompted to during the programming procedure.
The clutch programming does not even try to program and the gearshift programming gets as far as selecting all the gears engine off but will not go past confirming first gear correct when the engine is running. The only fault code stored is parameters not programmed and the only abnormally in the live data is the vehicle speed at 99kph ( but only in the gearbox ecu).I have tried using the KTS and Vaux-com both with the same results and have re-traced all steps to remove the gearbox and all seems OK. Any ideas please as my customer and i are becoming frustrated!Many thanks in advance Allan
Message Thread
« Back to index | View thread »
Copyright © uk autotalk