Year of Manufacture *: 04
(It does the "Runs for 2 seconds and stops" thing)
Locking and unlocking the car (either by key or remote) does NOT clear the non-start condition.
It is nececarry to use a scan tool to access the ECM, check for faults (None found #) and then do a "Clear codes" action.
After that it is fine...
Until next time.....!
Other than this everything is fine! Any suggestions??
(# Multiscan does not appear to have direct scan access to the immo on this model, If it did I might have more info. But clearing the "fault" from the ECM menu seems to do the trick)
Message Thread
« Back to index | View thread »
Copyright © uk autotalk