Hi

This car had a slight impact repair to the rear O/S panel. Since the repair the SRS warning light has been on.

DTC 10 drivers head airbag (TIS) resistance low.

I have checked the wiring to the ECU (OK}
The owner has masses of parts so we have also substituted the ECU, the curtain airbag and have soldered another connector on the airbag end.

The fault still exists.

If I fit a 3 ohm resistor into place the code will delete and stay away.

I have tried the right airbags on the left circuit and they appear fine and the codes for the left curtain airbag will delete.

I have tried four different scanners on this, Autodiagnos, Hanatech, Hanatech P1 and a G Scan. All repaor the same code and will not delete it.

Help before I have no hair left.

Regards

Simon