Year of Manufacture *: 2011
( Optional ) Engine Code or CC: 2.0l
Any way long story short the mechatronic unit was scrap (previous garage ripped the wiring ribbon) and fitted new unit and couldn't get it programmed
so I bought car and programmed unit using KTS590 and etis the first time it was unsuccessful but it re-done the programming and came back successfully installed but I can't get the calibrations to preform it just cuts out of calibration and comes back with long ford error code (01.10.01.00.00.00.00.00.00.00.00.00) and a P283E shift fork C position circuit high I'm pretty sure the mechanical size of box is okay and as the shift fork position sensor is part of the mechatronic unit there must be a fault within it. so my question is can I wipe the programming on the TCM and reprogram with VCMII and etis which I now have. According to Ford once the unit is programmed that's it no going back I'm thinking the unit programming has a glitch. I've have a second hand gearbox with mechatronic unit coming but would like to get to bottom of this one
Message Thread
« Back to index | View thread »
Copyright © uk autotalk