1.NOTE: If no specific time interval is given, each step should be performed within 30 seconds of the previous step.
2.Remove and insert key 1 five times at no more than 1-second intervals.
1.After the final key insertion, verify that the security light flashes. (300 ms ON300 ms OFF)
2.Wait for 5 minutes until the security light flashes at 1.2-second intervals.
3.Input the code word. For additional information, refer toCode Word Input Procedure in this procedure.
4.After verifying that the security light has switched from flashing to straight illumination, turn the key to the ON position.
5.After verifying that the security light goes off, turn the key to the LOCK position and remove from the steering lock.
3.Insert key 2 into the steering lock and turn the key to the ON position.
1.Verify that the security light illuminates for 12 seconds.
2.After verifying that the security light goes off, turn the key to the LOCK position and remove from the steering lock.
4.Insert key 3 into the steering lock and turn the key to the ON position.
1.Verify that the security light illuminates for 12 seconds.
2.After verifying that the security light goes off, turn the key to the LOCK position.
5.If there are 48 keys (valid and/or new keys), repeat Step 5 with each key.
6.Wait for 30 seconds.
7.After reprogramming, clear DTCs stored in the PCM.
I've emailed the CODE WORD procedure for security reasons.
Message Thread
« Back to index | View thread »
Copyright © uk autotalk