Posted by Matt Mansfield
on 11/20/2008, 6:29 pm
97.117.163.68
I am trying to:
1. Start a timer.
2. Then initiate the (continuous rotating) servo to spin clockwise (and/or counter clockwise) until
3. IN3 = 1, and/or until I switch it to stop, then
4 Stop the timer (timecounter) and
report time (by sending that number to PLX-DAQ Excel)
All of this so I can account for how long I caused the motor to spin (from the time of its initial begin command to the time I hit the switch to stop it).
I think I'm doing something wrong b/c I keep looping it to death and my times are all messed up. I'm using BASIC Stamp v2.2.
Does anyone have any thoughts?
I have posted on the parallax.com website also, but no responses
Message Thread:
« Back to thread