[ Post a Response | rolling START! Message Board ]
Posted by kellyracing Link: http://www.incarace.co.uk
on August 20, 2004, 4:46 pm, in reply to "Incarace Hot Ford spec"
82.41.156.251
hi, we built a hotford for incarace 506 just used a normal banger roll bar welded the door plate on to the side of the a and b pillars , then we put a bar diagonally from chest height on the roll bar down to the drivers foot well were it is bolted to the floor behind the door plate, you cannot shove metal through the pillars alternatively you can have a normal four post roll cage if you haven't got the specs they are available online using the link below and under the subsection formulas racing.
Message Thread:
« Back to thread