[ Post a Response | Rover Forum ]
Posted by Jason
on 5/19/2009, 3:40 pm, in reply to "bleeding brakes"
70.189.82.190
old fashioned way is still the best. Start at the right rear and move toward the master cylinder. Not sure if you have done it before, but get a friend and have them press the pedal while opening the bleed screw. Have them hold it on the floor while you tigten the screw. Use clean DOT4 fluid and repeat until the fluid is clear. If it is new to you, then new fluid is a good idea. It will take about 3 pints.
Responses: