The Forward Forum
[ Post a Response | The Forward Forum ]
Re: FC150 Door adjustment
Posted by Mark From Wisconsin on 8/9/2017, 18:00:49, in reply to "FC150 Door adjustment"
I pulled both drivers and passenger doors off for inspection, cleanup and patching. The Allen screws were the toughest component. Heat worked well in addition to an impact Allen screw driver. Be careful hitting the allen screws as you can damage the door by smacking too hard. the doors are easily aligned, I put the drivers door back on by myself, but the glass was removed and lightened the load. my doors had a couple of pin holes, but were in most excellent condition. When the doors are off, take a close look in the corner at the lowest points of the interior. Remove the freaking sealant that was applied at the factory, as it only holds water (the only place the door had the pin holes was where the sealant was pushed into the corners...) I Por coated the interior of both doors. its pretty easy, much easier to clean, inspect, fix any issues. Mark from Wisconsin
: I have heard that FC doors are hard to adjust
: and to never take the doors off.
: I have in fact heard that several times.
: However I need to raise the rear of my
: driver door, its sagging.
: Can anyone help me with a successful
: process, or things not to do???
: Thanks in advance for the help
Hosted for FREE by Boardhost.
Create your own free message board!