The Forward Forum
[ Post a Response | The Forward Forum ]
Master cylinder banjo fitting
Posted by Bruce Hamilton on 5/23/2017, 19:36:51
My master cylinder has been leaking, a lot! So I ordered a new one from Carl. Don't forget to order the the two copper washers. It turns out that the leak is from a crack on the banjo fitting where the fluid lines connect. The brake light switch also sits in a threaded hole in the top of the banjo fitting. Carl has to make those up special for the FC's and he doesn't have any in stock. The banjo fitting is on its way. If I am going to make the Memorial Day parade I am going to have to drill the fitting and thread it for the switch. I would expect it to be a pipe fitting thread. Does any one have any experience with this type of job that could tell me the what size drill and tap to use?
Hosted for FREE by Boardhost.
Create your own free message board!