Posted by Justin
on 9/12/2012, 3:13:33, in reply to "The real problem"
69.246.80.235
Thanks I need to look back at it with an open mind when I have time.Thanks so much for the pointers
--Previous Message--
: I pulled engine out of fc 57/58 with a spun
: bearing.put new rings so in 62 end gap on
: rings fine, head seats fine. I installed 57
: head on 62 engine now I know the year.I 99%
: sure the timing is correct.With head off if
: you put your hands over cylinders and turn
: over you will basically almost lose your
: hand=has compression.Install headed I know
: intake valves setting is correct.I have
: basically no compression in any cylinder.I
: have a manual on the way.I have never in my
: life encountered a problem like this on any
: engine.I thought timing double checked?I
: believe it's fine.Is there a difference in
: the 57=62 heads 4 cylinder none I have
: noticed with basic eye and calipers.engine
: 57 that came out just noticed minor
: differences in valve adjustment.At this
: point I am at a loose I do not know.It may
: be so simple it's in front of me. Any advise
: I have never been so frustrated.
:
Message Thread
« Back to index