Posted by TimC
on 8/3/2012, 12:55:53, in reply to "Re: Wiring Help?"
107.2.211.147
Hi Richie, yes, I have a ground strap from engine to frame - I had to make sure the connections were good on that one, it has been a gremlin on other vehicles.
Still searching...
Tim C
--Previous Message--
: Have you grounded the engine block to the
: frame?
: --Previous Message--
: Ok, I think I have tried as many corrections
: as I can concieve in my ignition circuit.
:
: I am using the wiring diagram from the
: manuals, and yes, I have a hard time
: following those tiny lines!
:
: Here is what I have:
: Battery Neg to Frame
: Battery Pos to Starter Solenoid
: Battery other side to Starter
: Solenoid Positive(Battery Side) to Batt on
: Voltage Regulator
: Batt or Volt. Reg to Bat on Ignition Switch
: Center post on Ignition Switch to top post
: on Starter Solenoid
: Voltage Regulator Arm and Fld to Generator
: posts (the posts on Gen are not marked)
: 3rd post on Generator to Ground on Voltage
: Regulator
: Ground on Voltage Regulator to Frame
: Acc on Ignition Switch to 12V Gauge +
: 12V Gauge - to Ground on Voltage Regulator
:
: Gauge shows 12V when in the Acc or On
: position
: Gauge drops to Zero when turned to Ignition
: (momentary position)
: No click from Solenoid
: No turn from the starter
:
: Any thoughts?
:
: I will probably pull the starter to bench
: test it, but it was rebuilt, so I doubt
: there is an issue there.
:
: I am also going to try another battery, just
: to make sure I am not failing a load test.
:
: Any help in plain english will be greatly
: appreciated.
:
: Tim C
:
:
:
:
Message Thread
« Back to index