Posted by Curt S.
on 11/7/2009, 0:21:41, in reply to "Re: FC resin model kit"
71.129.155.113
There are a handful of Cottage industries popping out resin that turn out pure crap, I've partnered up with a friend and we are about to launch a new company making after-market resin parts for aircraft models. we've invested in a vacuum chamber and pressure pot, to help get quality castings without a ton of air bubbles.
As far as this FC-150 goes,If the price was a bit lower (like half) I'd like to get one, but who knows with that poor quality photo, and at $50 it would be a fair price if the quality was top notch.
Curt
--Previous Message--
: I did a little research on Frontier Resin
: Design which is the company that makes this
: and other models too. General complaint is
: poor quality, proportions off, rough
: castings, too expensive for the quality and
: shipping is expensive. One comment on the FC
: was that it was pretty good but lacked
: detail. Another comment about their trucks
: (50's Dodges)was at least they're available.
:
: --Previous Message--
: Here is a model kit on ebay
:
: http://cgi.ebay.com/1957-62-willys-forward-control_W0QQitemZ230395815925QQcmdZViewItemQQssPageNameZRSS:B:SRCH:US:101
:
:
:
Message Thread:
« Back to thread