Posted by Jesse Ybarra
on 10/6/2009, 3:00:18, in reply to "Rivits"
64.12.117.15
I use Duro product Navel Jelly, let it sit as per directions, wash it with water and a small amount of green Palmolive dish soap, I rinse real good with my pressure washer, then immediately use a hot air gun or a hair dryer. Then when dry, imediately apply Por 15, with a brush and use clean dry air pressure to force the Por 15 in, then I do another coat later to seal it completely, when it dries the brush strokes disappear, follow the Por 15 directions on how to re-close the lid on the can. then lightly sand and touch up with paint, if you want.
--Previous Message--
: I let my newlly painted frame get rained on.
: Rust is bleeding out from behind the body
: support clips where they are rivited to the
: frame.
:
: Options I see are to grind off the rivits,
: spot sand blast, and reattach the clips, but
: how?
:
: Bolts - I don't like that idea, as it will
: not look stock and could come loose.
:
: Weld - Could use weld through primer and
: seam weld them. That is a lot of work.
:
: Or, I could clean up the rust stains as they
: occur and live with it.
:
: Suggestions welcome.
:
: Thanks,
:
: Gary
:
Message Thread:
« Back to thread