Posted by Vince
on 9/10/2009, 10:25:55
68.13.139.31
Hey all, I have been exchanging emails with Dan and Craig (Thanks a ton guys) about an issue with the brakes on my 170. I am unable to get a firm pedal. I have replaced the master cylinder (bench bled before installing), replaced all 4 wheel cylinders and all rubber lines. I have bled the lines 8 or 10 times starting in the pass rear to drivers rear to pass front and then drivers front. I have my son pump until the pedal is firm and hold down. I open the bleeder valve and close it before it stops flowing. The last 5 or 6 times, I have gotten no air out of the lines, but the pedal is still soft. I have checked all the connections and there aren't any leaks along the way. I'm a little frustrated and would appreciate any suggestions.
Vince
Message Thread:
« Back to thread