Posted by Craig B.
on 7/19/2009, 22:25:03, in reply to "Re: DRW bed"
205.188.117.15
Not sure, there were so many different applications installed by different dealers across the country. I saw one at the Spring Reunion that had a piece of I-beam with the web cut to the contour of the frame and the flange welded back on. It was real slick setup.
Craig
--Previous Message--
: Were the factory configurations all with
: timbers?I have a welded steel setup that has
: boltdowns using the factory bed
: brackets.Seems like I saw another setup in
: years past that was steel also.But I guess
: they both could have been aftermarket
: fabrications.Just curious as to the
: authenticity of it.Thanks Bob
:
: --Previous Message--
: Here's a few pictures from a page I made
: some
: time ago. It shows different bed fastening
: methods. A quick answer is they did it many
: different ways. Most stock configurations
: that I have seen cut a timber to the profile
: of the frame and then used u-bolts to fasten
: the bed to the frame. I hope this helps,
:
: Craig
:
:
:
Message Thread:
« Back to thread