Posted by Rob Haut on 5/12/2008, 12:46:01, in reply to "Re: steering wheel removal"
24.229.25.38
Thanks, I'll make one of my own. Nice job BTW.
I think I'll use some anti-seize goo in the splines when I install the new wheel.
Rob
--Previous Message--
:
: The secret is pressure. I made a puller out
: of some stuff laying around the shop. Three
: u-bolts spaced around a disc of metal that
: gives a constant pull on the wheel. Drop a
: metal slug down the hole in the center of
: the wheel to give you something to push off
: of without messing up the steering shafts
: threads and you're good to go.
:
: Craig
:
: --Previous Message--
: I'm trying to remove the old steering wheel
: from my 170. I assume it has splines mating
: with splines on the tube. after removing the
: nut, I've pounded up with a wooden block on
: the bottom of the wheel at the tube but it
: won't budge (soaked the hub with liquid
: wrench). I can't get a puller on it since
: there is only plastic to grab onto.
:
: Since I don't need to save the old wheel, I
: could cut away the plastic and heat the
: steel hub but I've rather not use heat.
:
: What's the secret?
:
: Thanks,
: Rob Haut
: West Chester PA
:
:
:
Message Thread:
« Back to thread