Posted by Maliboost on January 13, 2009, 5:06 pm
68.7.68.112
I have pictures of some of it @ http://www.xtrmbowties.com/StuffForSale.html
~~~ I have a set of 32 x 14.5 x 15's Mickey Thompson tires off of my Chevelle that I want to get rid of. I dont think I have 20 or maybe 24 passes on them up @ Barona. Im going with a smaller tire. I think they are 4 years old, but have been stored in my garage up off of the ground. Make offer
~~~ I have a set of Moroso Trick springs for the front of my 66 Chevelle. they are for a BBC. part number 47195 Big Block Chevy; Front End Weight: 1750 - 1810 lbs; Coil Spring Rate: 250 lbs/in Make offer.
~~~ K&N Filter & filter top. std 14" guy for carb filter bases. I dont have the base. Make offer.
~~~ Plate nitrous system. Its a NOS Double Cross bar plate that was flowed by Jeff Prock @ Applied Nitrous Technology (www.appliednitroustechnology.com). It comes with both the NOS tune ups & the Prock tune-ups. This system can be used as a single stage or a dual stage system. Its setup now for single stage, but if you get another set of noids you could use it as a 2 stage setup.
It has an NOS purge noid, but the large ID Peter-Paul Noids for fuel & N2O. I rebuilt them last summer & I do have another set of rebuild kits for them. The noids have been ported for reduced back pressure.
I have two 15 Lbs bottles (that are full). I put pressure switches in both of the bottles so that the bottle heater can be on w/o the valve being open. The bottle heater does come with it as well. I'm also selling the NOS brand -6 Nitrous filter that I use to filter the nitrous as it goes INTO the bottle. I do NOT run a filter between the bottle & the solenoid, however, this filter will work if you decide to run it between the bottle & noid.
I have a Holley Fuel pressure regulator that was modified by Prock for better repeatability & the higher tune-ups.
This plate system was on Roger Hayes' Nova for a while when he had a 4150 on it, & it was on my car for about a year. It took my car from 7.8's to 6.40's in the 1/8th (that’s 10.0’s in the 1/4) on the "200 HP" shot. It was DEAD ON & has GREAT distribution. It never so much as nipped a single plug. Make reasonable offer on it all.
~~~ 1966/67 Chevelle Pin on Glasstek deck lid. brand new, never been on a car, no holes in it $50
~~~ 1966 Chevelle front bumper, steel, good shape. $100
~~~ 1966/67 Chevelle Rear Bumper, Steel, Good shape $100.
send me an email to xtrm66 at cox . net & I will shoot you my phone number.
thanks
Bob
Message Thread:
« Back to thread